Description:
Nu-Vue Snap Lock Roofing Panel is a factory formed continuous interlocking, concealed clip, architectural standing seam metal roof panel with a proven seam design that snaps together for ease of installation. The panel is available in a wide variety of materials and finishes including PVDF coated G- 90 Galvanized steel, AZ-50 Galvalume steel, and Aluminum as well as Copper. An optional thermally-applied pre-assembly in-seam sealant is available.
Method of Application:
1. Nu-Vue Snap Lock panels must be installed in a sequential
pattern.
2. Application of a Nu-Vue approved underlayment prior to
panel installation is recommended.
Storage:
1. Nu-Vue metal panels should be stored in a well ventilated, dry place where no moisture can contact them. Moisture (from rain, snow, condensation, etc.) trapped between layers of material may cause water stains or white rust, which can affect the service life of the material and will detract from its appearance.
2. If outdoor storage cannot be avoided, protect the panels with a ventilated canvas or waterproof paper cover. Do not use plastic, which can cause condensation. Keep the material off the ground in an inclined position with an insulator such as wood. Protective film may degrade or become brittle with long term exposure to direct sunlight.
Precautions:
1. Oil canning is not a cause for rejection.
2. Heavier gauges, narrower widths, striations, and
embossing minimize oil canning.
3. Sealant for end laps and lap joints shall be non-drying,
non-toxic, and non-shrinking with a serviceable temperature
of 0 to 212 degrees F .
4. Quality, long-life butyl sealants work best as a gasket
sandwiched between two pieces of metal. Non-acetic cured
silicone color matching sealants are recommended when
voids must be filled. Sealants are not a substitute for proper
assembly and workmanship.
5. Exercise caution when lifting, moving, transporting, storing or
handling Nu-Vue metal to avoid possible physical damage.
6. Refer to Material Safety Data Sheets (MSDS) for safety
information.
7. Immediately remove protective film after installation. |
