Recomended link:

Architectural Panels

Standing Seam

Snap Lock

U Panels or Snap On

Soffit

Tropical

V or Type D

Vista Nu or Type E

Wall Panel

Honeycomb

Composite

Aluminum Plate

Structural Panels

Roof Deck or Type B

Steel Form

Structural Sections

Cee Purlins

Zee Purlins

Drywall Stud

Drywall Track

Hat Sections

Application Method:

Self Advesive can be installed over Nu-Vue ISO 95+TM GL, HailGardTM Composite insulation, ISOGARDTM HD Cover Board, ResistaTM insulation, OSB, and plywood. Self Adhesive must be fully supported. Contact Nu-Vue Roof Solutions for details.

1. Start at the lowest part of the roof deck and install the valleys first. Lay the membrane flat in place with the print side up.
2. Cut the Self Adhesive to a length that can easily be managed.
3. Along the side of the sheet, overlap the seams a minimum of 3" (76 mm).
4. At the ends of the sheet, overlap a minimum of 6" (152mm).
5. Peel half of the release liner off the roll diagonally and apply with heavy, even hand pressure or brooming from the center of the sheet to the outer edges. Remove the remaining release liner from the other half of the roll and apply pressure in the same manner. Use of a hand roller at the laps is recommended.
6. In very steep slope applications, back nailing may be recommended. When back nailing, be sure that all nails are covered by the next overlapping sheet.

1. Review Material Safety Data Sheet (MSDS).
2. Take care when transporting and handling Nu-Vue
   Self Adhesive rolls to avoid punctures and other types
   of physical damage.
3. Isolate waste products, petroleum products, grease, oil
   (mineral and vegetable) and animal fats from all Nu-Vue
   Self Adhesive Rolls.
4. Contact Nu-Vue Roof Solutions Department for specific
   recommendations.
   

Storage:

• All material should be stored out of the weather in a clean, dry area in its original unopened packaging at a minimum of 50°F(10°C)andamaximumof140°F (60°C)sothatit will be a 50 °F (10 °C) or above at the time of application.
• If material must be stored temporarily on the roof before application, it must be elevated from the roof surface on a pallet, and covered from the weather with a light colored opaque tarp in a neat, safe manner that does not exceed the allowable load limit of the storage area.